ascensor retención válvula

Ascensor tipo retención válvula
GB/T12235 design, bolted valve bonnet, lifting valve disc


Visión general
Check valve refers to a valve whose opening and closing parts are circular discs and rely on their own weight and medium pressure to act to block the reverse flow of the medium. It belongs to the automatic valve category, also known as check valve, one-way valve, return valve or isolation valve. The movement mode of the valve disc is divided into lifting type and swing type. The structure of the lift check valve is similar to that of the globe valve, except that it lacks the valve stem that drives the valve disc. The medium flows in from the inlet end (lower side) and flows out from the outlet end (upper side). When the inlet pressure is greater than the sum of the weight of the valve disc and its flow resistance, the valve is opened. On the contrary, the valve is closed when the medium flows back. The swing check valve has an inclined disc that can rotate around its axis, and its working principle is similar to that of the lift check valve. Check valves are often used as foot valves in water pumping devices to prevent the backflow of water. Check valves and stop valves are used in combination to provide safe isolation. The disadvantage is that the resistance is large and the sealing is poor when closed.
1. En orden para prevenir el reflujo de el medio, válvulas debe estar instalado en equipo, dispositivos y tuberías;
2. Las válvulas de retención son generalmente adecuadas para medios limpios y no son adecuadas para medios contienen sólidos partículas y alta viscosidad;
3. Generalmente, horizontal elevación retención válvulas debe ser usado en horizontal tuberías con a diámetro nominal de 50 mm;
4. El Recto elevación retención válvula puede solo ser instalado en horizontal tuberías;
5. Para la bomba agua entrada tubería, a fondo válvula debe ser usada. La válvula inferior es generalmente sólo instalada en la tubería vertical en la bomba entrada, y el medio fluye desde fondo hasta arriba;
6. El tipo elevación tiene mejor sellado y mayor fluido resistencia que el tipo oscilación . El tipo horizontal debería estar instalado en tuberías horizontales, y el tipo vertical debería estar instalado en tuberías verticales;
7. La instalación posición de la oscilación de retención válvula es no restringida. Puede ser instalada en horizontal, vertical o inclinada tuberías. Si it está instalada en una vertical tubería, el medio flujo dirección debe ser desde abajo a arriba;
8. The swing check valve should not be made into a small-diameter valve. It can be made into a very high working pressure. The nominal pressure can reach 42MPa, and the nominal diameter can also be very large, up to 2000mm or more. Depending on the materials of the shell and seals, it can be applied to any working medium and any working temperature range. The medium is water, steam, gas, corrosive medium, oil, medicine, etc. The working temperature range of the medium is between -196--800 degree ;
9. The swing check valve is suitable for low pressure and large diameter, and the installation location is limited;
10. La instalación posición de la mariposa de retención válvula es no restringida y puede ser instalada en horizontal tuberías, o en vertical o inclinadas tuberías;
Aplicaciones
Agua tuberías, alcantarillado tuberías, industriales tuberías, agrícolas tuberías


Etiqueta: dn80 WCB brida elevación retención válvula, China , fabricantes, proveedores, fábrica , comprar, precio , cotización
